Casio 3744 Watch User Manual


 
1
Operation Guide 3744
MA0408-EA
Setting the Time and
Date
To set the day
1. Pull the crown out to the first
click.
2. Rotate the crown towards you
to advance the day setting.
3. Push the crown back in to the
normal position.
To set the time and day of
the week
1. When the second hand is at
12 o’clock position, pull the
crown out to the second click.
This will cause the second
hand to stop.
2. Rotate the crown to move the
analog hands and set the day
of the week.
Rotating the hands past midnight will cause the day of the
week setting to change. Keep rotating until the day of the
week is the setting you want.
3. After setting day of the week, rotate the crown to set the analog
hands to the current time.
Make sure you set the time correctly as AM or PM.
4. Listening for a time signal on the TV or radio, push the crown
back in at the top of a minute.
Moon Phases
The Moon goes through a regular 29.53-day cycle during which it
appears to wax and wane due to how the Sun illuminates the
Moon and the relative positioning of the Earth, Moon, and Sun.
The greater the angular distance between the Moon and the
Sun,* the more of the Moon we see illuminated.
* The angle to the Moon in relation to the direction at which the
Sun is visible from the Earth.
Moon Phase Indicator
The Moon phase indicator of this watch indicates the current
phase of the Moon as shown below.
New Moon
07
First Quarter
(Waxing)
Full Moon
15 22
Last Quarter
(Waning)
Moon Phase
Moon Age
Moon Phase
Indicater
The Moon phase indicator shows the Moon as viewed at noon
from a position in the Northern Hemisphere looking south. Note
that at times the image shown by the Moon phase indicator may
differ from that of the actual Moon in your area.
The left-right orientation of the Moon phase is reversed when viewing
from the Southern Hemisphere or from a point near the equator.
Adjusting the Moon phase
1. Pull the crown out to the first click.
2. Rotate the crown away from you until there is nothing visible in
the Moon phase indicator (moon age of 0).
3. Slowly rotate the crown away from you again until the Moon
phase indicator shows the correct Moon phase.
For details about Moon phases, see Moon Phase Indicator
above.
4. Push the crown back in to the normal position.
Avoid setting the day-date between 8:00 p.m. and 1:00 a.m.
(If you do, the day-date setting may not change in the following day).
For watch with the elapsed time bezel
Rotate the elapsed time bezel to align the
mark with the minute hand.
After certain amount of time elapsed, read the
graduation on the elapsed time bezel which
the minute hand points to.
The elapsed time is indicated.
Some water resistant models are equipped
with a screw lock crown.
With such models, you must unscrew the
crown in the direction noted in the illustration to
loosen it before you can pull it out. Do not pull
too forcibly on such crowns.
Also note that such watches are not water
resistant while their crowns are loosened. Be
sure to screw the crowns back in as far as they
will go after making any setting.
50
40
30
20
10
Elapsed time bezel
60
15
30
45
Crown
(Normal
position)
First click (for setting
the day and moon phase)
Second click (for setting
the time and day of the week)
DayDay of week
Moon phase indicator
The configuration of your watch
may differ somewhat from that
shown in the illustration.