Casio 5192 Watch User Manual


 
Operation Guide 5192
E-3
Things to check before using the watch
1. Hold down C for about two seconds to enter the Timekeeping Mode, and
then observe the movement of the
x
Second Hand.
Is the
x
Second Hand moving smoothly at one-second intervals?
Is the
x
Second Hand moving at
two-second intervals or is it stopped
completely?
Go to step 2.
The watch is charged suffi ciently.
For details about charging, see
“Charging the Watch” (page E-8).
Power is low. Charge the watch by placing
it in a location where it is exposed to light.
For details, see “Charging the Watch”
(page E-8).
NO
YES
YES
NEXT
MA1011-EA
E-1
ENGLISH
Congratulations upon your selection of this CASIO watch.
E-2
About This Manual
Button operations are indicated using the letters A through
D shown in the illustration.
Hand Functions
z
Hour Hand
x
Second Hand
c
Minute Hand
v
Left Dial Hand:
Indicates the current day of the week and current mode.
b
24-hour Hand:
Indicates the current 24-hour timekeeping hour.
The long end indicates the current hour between 18:00
and 6:00. The short end indicates the current hour
between 6:00 and 18:00.
n
Right Dial Hands:
Indicate a time, in 24-hour format, depending on the current mode.
m
Day
This User’s Guide uses numbers shown above to identify watch hands and indicators.

B +
* 6> 5
@
E-4
2. Check the Home City and the daylight saving time (DST) setting.
Use the procedure under “To confi gure Home City settings” (page E-20) to confi gure
your Home City and daylight saving time settings.
Important!
Proper World Time setting depend on correct Home City, time, and date settings in
the Timekeeping Mode. Make sure you confi gure these settings correctly.
3. Set the current time.
x To set the time
See “Confi guring Current Time and Date Settings” (page E-25).
The watch is now ready for use.
E-5
Contents
E-2 About This Manual
E-3 Things to check before using the watch
E-8 Charging the Watch
E-15 To recover from the sleep state
E-16 Mode Reference Guide
E-17 To determine the watch’s current mode
E-17 To return to the Timekeeping Mode from any other mode
E-18 To select a mode
E-19 Timekeeping
E-20 Confi guring Home City Settings
E-20 To confi gure Home City settings
E-6
E-23 To toggle the Home City time between standard time and daylight
saving time
E-25 Confi guring Current Time and Date Settings
E-25 To change the current time setting
E-29 To change the current date setting
E-34 Using the Stopwatch
E-34 To perform elapsed time measurement
E-35 To perform an elapsed time operation
E-35 To pause at a split time
E-38 Checking the Current Time in a Different Time Zone
E-39 To view the time in another time zone
E-40 To specify standard time or daylight saving time (DST) for a time
zone
E-42 To swap your Home City and World Time City
E-44 Using the Alarm
E-7
E-45 To change the alarm time setting
E-45 To turn the alarm on or off
E-45 To stop the alarm
E-46 Adjusting Home Positions
E-47 To adjust home positions
E-51 Troubleshooting
E-56 Specifi cations
E-8
Charging the Watch
The face of the watch is a solar cell that generates power from light. The generated
power charges a built-in rechargeable battery, which powers watch operations. The
watch charges whenever it is exposed to light.
Charging Guide
Whenever you are not
wearing the watch, leave
it in a location where it is
exposed to light.
Best charging
x
performance is achieved
by exposing the watch to
light that is as strong as
possible.
When wearing the watch,
make sure that its face is
not blocked from light by the
sleeve of your clothing.
The watch may enter a
x
sleep state (page E-14) if
its face is blocked by your
sleeve even only partially.
E-9
Warning!
Leaving the watch in bright light for charging can cause it to become quite hot.
Take care when handling the watch to avoid burn injury. The watch can become
particularly hot when exposed to the following conditions for long periods.
On the dashboard of a car parked in direct sunlight
x
Too close to an incandescent lamp x
Under direct sunlight x
Important!
Keep the watch in an area normally exposed to bright light when storing it for long
x
periods. This helps to ensure that power does not run down.
Storing the watch for long periods in an area where there is no light or wearing it in x
such a way that it is blocked from exposure to light can cause power to run down.
Make sure that the watch is exposed to bright light whenever possible.