Sanus Systems VM3 TV Mount User Manual


 
Assembly Instructions for VisionMount
LCD Wall Mount Model: VM3
Required Tools:
Drill with 3/16” bit, Phillips screw driver
(2) Wall Mount Screws - a (1) Allen Key - b
(4) M4 Bolt - e (4) M5 Bolt - f (4) Knob Replacement
Bolt - g
(1) Monitor Mount - d
(1) Large Washer - h (1) Cap - i (1) Small Washer - j (1) Knob - k
1] Attaching to the Television:
Attach the Monitor Mount (d) to the back of your LCD television using the proper bolts as shown in Diagram 1. Place 4 bolts through the
Monitor Mount and tighten snugly into the VESA bolt mounting pattern on the back of the television. Make sure the large side of the tapered hole on the Monitor Mount faces
toward the bottom of the television. M4 (e) and M5 (f) bolts are provided. Other sizes are available at your local hardware store.
2] Attaching to the Wall:
Hardware for
wood stud
mounting is provided. For all other mounting applications contact a specialist. Use a high quality stud sensor to locate a
stud. It is a good idea to verify the stud location with an awl or thin nail as shown in Diagram 2A. Use the Wall Plate as a template to mark the two hole locations on the wall.
Make sure these holes are aligned vertically and centered over the stud. Pre-drill the two holes using a 3/16” drill bit. Attach the Wall Plate to the wall using the two Wall Mount
Screws (a) as shown in Diagram 2B. Tighten the Wall Mount Screws with the Allen Key (b) until they are snug.
(1) Wall Plate - c
(1) Wall Plate - c
Thank you for choosing Sanus Systems Vision Mount furniture. This product is
designed to mount VESA 75/100 compatible LCD televisions up to 30 pounds
onto a vertical wall. It allows you to effortlessly tilt and swivel your new televi-
sion up to 15° in either direction as well as extend it up to 12” away from the wall
without the use of tools. Check carefully to make sure there are no missing or de-
fective parts. Never use defective parts. Improper installation may cause damage
or serious injury. If you do not understand these directions, or have any doubts
about the safety of the installation, please call a qualifi ed contractor or contact
Sanus at 800.359.5520 or www.sanus.com. We can quickly assist you with in-
stallation questions and missing or damaged parts. Replacement parts for Sanus
products purchased through authorized dealers will be shipped directly to you.
Sanus Systems
2221 Hwy 36 West. St. Paul, MN 55113
800.359.5520 www.san
us.com 7.
8.04