Sony SRS-D211 Speaker User Manual


 
SONY SRS-D211 (GB/FR/ES) 2-593-588-11(1)
POWER
ON
OFF
VOLUME
BASS
MIN MAX
MIN MAX
PHONES
POWER
ON
OFF
VOLUME
BASS
MIN MAX
MIN MAX
PHONES
B
2005 Sony Corporation Printed in Malaysia
Operating Instructions
Mode d’emploi
Manual de instrucciones
Active Speaker System
SRS-D211
2-593-588-11(1)
POWER
VOLUME
to wall outlet
D
*
“WALKMAN” is a registered
trademark of Sony Corporation to
represent Headphone Stereo products.
CD/MD Walkman*, etc.
PC, etc.
On operation
Do not drive the speaker system with a continuous
wattage exceeding the maximum input power of the
system.
Before connecting, turn off the speaker system, the
PC and audio component to avoid damaging the
speaker system.
The volume level should not be turned up to the
point of distortion.
Although this system is magnetically shielded, do not
leave recorded tapes, watches, personal credit cards
or floppy disks using magnetic coding in front of the
system for an extended period of time.
If the TV picture or monitor display is
magnetically distorted
Although this system is magnetically shielded, there may
be cases that the picture on some TV sets/personal
computers may become magnetically distorted. In such a
case, turn off the power of the TV set/personal computer
once, and after 15 to 30 minutes turn it on again. In the
case of a personal computer, take appropriate measures,
such as data storage, before turning it off.
When there seems to be no improvement, locate the
system farther away from the TV set/personal
computer. Furthermore, be sure not to place objects in
which magnets are attached or used near the TV set/
personal computer, such as audio racks, TV stands, toys
etc. These may cause magnetic distortion to the picture
due to their interaction with the system.
On placement
Do not set the speakers in an inclined position.
Do not leave the system in a location near heat
sources, or in a place subject to direct sunlight,
excessive dust, moisture, rain or mechanical shock.
Do not install the satellite speaker anywhere other
than on a wall.
Do not hang anything on the satellite speaker.
On cleaning
Do not use alcohol, benzene, or thinner to clean the
cabinet.
If you have any questions or problems concerning your
speaker system, please consult your nearest Sony
dealer.
to FRONT R jack
to FRONT L jack
Controller (rear)
to LINE OUT or
headphones jack
(stereo mini-jack)
PHONES
C
Controller
English
Before operating the unit, please read this manual
thoroughly and retain it for future reference.
WARNING
To prevent fire or shock hazard, do not expose the
unit to rain or moisture.
To avoid electrical shock, do not open the cabinet. Refer
servicing to qualified personnel only.
To prevent fire, do not cover the ventilation of the
apparatus with news papers, table-cloths, curtains, etc.
Do not place lighted candles on the apparatus.
To prevent fire or shock hazard, do not place objects
filled with liquids, such as vases, on the apparatus.
Do not install the appliance in a confined space,
such as a bookcase or built-in cabinet.
CAUTION
You are cautioned that any changes or modification not
expressly approved in this manual could void your
authority to operate this equipment.
NOTICE FOR THE CUSTOMERS IN THE USA
This symbol is intended to alert the user to
the presence of uninsulated “dangerous
voltage” within the product’s enclosure
that may be of sufficient magnitude to
constitute a risk of electric shock to persons.
This symbol is intended to alert the user to
the presence of important operating and
maintenance (servicing) instructions in the
literature accompanying the appliance.
Precautions
On safety
The nameplate indicating operating voltage, power
consumption, etc., is located on the rear exterior.
Before operating the system, be sure that the
operating voltage of the system is identical with that
of your local power supply.
Where purchased Operating voltage
U.S.A./Canada 120 V AC, 60 Hz
European countries 220 – 230 V AC, 50 Hz
Other countries • 120 V AC, 60 Hz
• 220 – 230 V AC, 50 Hz
The unit is not disconnected from the AC power
source (mains) as long as it is connected to the wall
outlet, even if the unit itself has been turned off.
Unplug the system from the wall outlet if it is not to
be used for an extended period of time. To disconnect
the cord, pull the cord by grasping the plug. Never
pull the cord itself.
Should any liquid or solid object fall into the system,
unplug the system’s power cord and have the system
checked by qualified personnel before operating it
any further.
The AC power cord should be changed only at a
qualified service shop.
For efficient heat dissipation, ensure there is sufficient
space to the rear of the subwoofer. Also, avoid
placing objects on the unit.
Do not insert your hand or any objects into the hole
of the subwoofer.
to INPUT 2
jack
to LINE OUT or
headphones jack
Connecting cord
(connected with controller)
Subwoofer with wired controller (1)
Satellite speaker (2) Stand (2)
A
,
A
B
,
Satellite speaker
Stand
Hollow wall anchor
(ø 4 mm, not supplied)
Anchor hole
Package Contents
PC, CD or MD
Walkman, etc.
Front speaker (Left)
Subwoofer
Controller
Front speaker (Right)
Installing the satellite speakers
(See fig. A)
The satellite speaker can be used either placed on a desk
or attached to a wall.
When you use the satellite speaker on a desk
(See fig. A-A)
By attaching the stand to the satellite speaker, it can be
placed on a desk.
1 Slide the stand into the slot at the
bottom of the satellite speaker.
The stand allows you to adjust the satellite
speaker to the desired angle.
2 Ensure the stands are locked.
Push the stand into the slot until a “click” sound is
heard.
Note
Do not put your finger into the slot of the satellite
speaker when you lock the stand. It may cause an
injury to your finger.
When you use the satellite speaker attached
to a wall (See fig. A-B)
The satellite speaker can be attached to a wall. Follow
the Notes (below) to install safely. Improper installation
may result in the speaker falling and causing bodily
injury or damage to the speaker or other object.
1 Secure the hollow wall anchor in the wall
— refer to the illustration.
Notes
Confirm wall thickness is sufficient. A
minimum thickness of 9.5 mm is recommended
for plasterboard.
Use the specified clamp (hollow wall anchor,
not supplied) when attaching to plasterboard.
Refer to the supplied operating instructions
using a hollow wall anchor.
Use wall anchors of at least 20 kg hanging
capacity.
Refer to the instruction supplied with hollow
wall anchor.
Requires ø 4 mm hollow wall anchor.
Set up the head of a hollow wall anchor 5 mm
from the wall.
Apply a bond (anaerobic threadlocking
material) to the hollow wall anchor to prevent
the screw loosening.
2 Attach the satellite speaker to the wall.
Insert the wall anchor in the anchor hole of the
satellite speaker.
Notes
Detach the stand from the satellite speaker
before attaching to the wall.
Ensure that the satellite speaker is securely
attached to the wall before use.
Hooking up the system
(See fig. B)
1 Connect the satellite speakers to the
subwoofer.
Confirm the location of the satellite speakers, and
then connect to their respective jacks.
2 Connect the controller to the source
equipment.
PC, etc.:
Connect the controller and the LINE OUT or
headphones jack of a PC, etc. with the connecting
cord (connected with the controller). For details,
refer to the operating instructions of the PC.
CD/MD Walkman, etc.:
Connect the INPUT 2 jack of the controller and the
LINE OUT or headphones jack of a CD/MD
Walkman, etc. The connecting cord is not supplied
with this system.
Note
Turn on either of the connected equipment to
listen to its sound.
3 Connect the subwoofer to the wall
outlet.
4 Position the speakers. (See fig. C)
Listening to the sound (See fig. D)
First, turn down the volume on the controller. The
volume should be set to minimum before you begin
playing the programme source.
1 Set the POWER switch to ON on the
controller.
The POWER indicator lights up.
2 Turn on the desired equipment
connected to the controller.
Note
Do not turn on both connected equipments as it
may cause double sound.
3 Adjust the VOLUME control on the
controller.
You can adjust the volume of the subwoofer and
each satellite speaker.
When connecting to the headphone output, also
adjust the volume of the connected component.
After listening, set the POWER switch to OFF.
The POWER indicator goes off.
Using the headphones/
earphones
Connect the headphones/earphones to the PHONES
jack on the controller.
Note
Turn off the MEGA BASS or BASS BOOST (Walkman,
etc.) function as it may cause audible distortion.
Troubleshooting
Should you encounter a problem with your speaker
system, check the following list and take the indicated
measures. If the problem persists, consult your nearest
Sony dealer.
There is no sound from the speaker system.
Make sure all the connections have been correctly
made.
Make sure the VOLUME dial and the each speaker’s
volume dial on the controller have been turned up
properly.
Make sure the connected component has been turned
up properly.
Check if the headphones are connected. If they are,
disconnect them.
The sound is distorted.
Turn down the volume level on the connected
component. Or, if the connected component has a
BASS BOOST function, set it to off.
Rotate BASS on this unit to reduce the bass volume.
Turn VOLUME on this unit down to reduce the
volume.
There is hum or noise in the speaker output.
Make sure all the connections have been correctly
made.
Make sure none of the audio components are
positioned too close to the TV set.
The sound has suddenly stopped.
Make sure all the connections have been correctly
made.
The brightness of the POWER indicator is
unstable.
The brightness of the POWER indicator may become
unstable when the volume is turned up. This is not a
malfunction.
Specifications
Speaker section
Satellite speaker
Speaker system Full range, magnetically shielded
Speaker units 5.7 cm, cone type
Enclosure type Closed type
Impedance 4
Cord length 2 m
Subwoofer
Speaker system Woofer
Speaker units 12 cm, cone type
Enclosure type Bass reflex
Impedance 8
Amplifier section
Rated output 5 W (10% T.H.D., 1 kHz, 4 )
(Satellite speaker)
25 W (10% T.H.D., 100 Hz, 8 )
(Subwoofer)
Input Connecting cord with stereo mini
plug (2m) × 1
Stereo mini jack × 1 (INPUT 2)
Input impedance 4.7 k (at 1 kHz)
Output Stereo mini jack × 1 (PHONES)
General
Dimensions (w/h/d) Approx. 50 × 140 × 99 mm
(2 × 5
5
/8 × 4 in.) (Controller)
Approx. 98 × 124 × 84 mm
(3
7
/8 × 5 × 3
3
/8 in.) (Satellite speaker,
on a desk)
Approx. 98 × 98 × 83 mm
(3
7
/8 × 3
7
/8 × 3
3
/8 in.) (Satellite
speaker, attached to a wall)
Approx. 163 × 267 × 301 mm
(6
1
/2 × 10
5
/8 × 11
7
/8 in.) (Subwoofer)
Mass Approx. 134 g (5 oz.) (Controller)
Approx. 294 g (10 oz.)
(Satellite speaker)
Approx. 4.2 kg (9 lb. 4 oz.)
(Subwoofer)
Cord length 2 m (Controller to subwoofer)
2 m (Power cord)
Power consumptions 18 W
Optional accessories
Connecting cord RK-G136, RK-G138
Plug adaptor PC-236MS
Design and specifications are subject to change without
notice.
Reverse the stand to
change the speaker
angle.
Note
First, be sure to apply a bond
(anaerobic threadlocking material)
to the hollow wall anchor to
prevent the screw loosening.
9.5 mm or more
ø 4 mm
5 mm
ø 7 mm
Note
Do not hang anything on the
satellite speaker.
Connecting cord
(not supplied)
Satellite speaker
(rear)
VOLUME: Controls total volume level.
BASS: Adjusts bass level (Subwoofer).
PHONES: Connect the headphones for personal listening.
Printed on 100 % recycled paper using VOC
(Volatile Organic Compound)-free vegetable oil based ink.
This warranty is valid only in the United States.
Subwoofer (rear)
01US_SRSD211 6/1/05, 11:07 AM1