York B2CH180 Heat Pump User Manual


 
GENERAL
YORK Model B*CH units are single package heat pumps
designed for outdoor installation on a rooftop or a slab. These
units can be equipped with factory installed electric heaters for
supplemental heating applications.
The units are completely assembled on rigid, permanently
attached baserails.Allpiping, refrigerant charge,and electrical
wiring is factory installed and tested. The units require only
electric power, duct connections and installation of fixed
outdoor air intake damper (units without economizer or
motorized damper option only) at the point of installation.
These units are designed and manufactured under ISO 9002
Quality System Certification
The supplemental electric heaters have nickel-chrome
elements and utilize single point power connection.
INSPECTION
As soonasa unit is received,it should be inspectedfor possible
damage during transit. If damage is evident, the extent of the
damage should be noted on the carrier's freight bill. A separate
request for inspection by the carrier's agent should be made in
writing. See Local Distributor for additional information.
REFERENCE
Additional information on the design, installation, operation
and service of this equipment is available in the following
reference documents:
55.70-N7- General Installation
55.70-N2 -Pre-start & Post-start Check List
44-320-10 - Barometric Relief Damper Accessory
Renewal Parts: - Refer to the Renewal Parts Manual for
complete listing of replacement parts on this equipment.
All forms referenced in this instruction may be ordered from:
Standard Register
Norman, Oklahoma 73069
Toll Free Telephone: 877-318-9675
Toll Free Fax: 877-379-7920
®
SUNLINE 2000
SINGLE PACKAGE AIR-TO-AIR
HEAT PUMPS
INSTALLATION INSTRUCTION
Supersedes: Nothing
035-18895-000-A-0902
Installer should pay particular attention to the words: NOTE, CAUTION and WARNING. Notes
are intended to clarify or
make the installation easier. Cautions
are given to prevent equipment damage. Warnings are given to alert installer that per
-
sonal injury and/or equipment damage may result if installation procedure is not handled correctly.
MODELS B2CH180
(WORLD 50 HZ)
CAUTION
THE ENCLOSED INSTALLATION INSTRUCTIONS AND ANY APPLICABLE
LOCAL, STATE, AND NATIONAL CODES INCLUDING, BUT NOT LIMITED
TO, BUILDING, ELECTRICAL, AND MECHANICAL CODES.
THIS PRODUCT MUST BE INSTALLED IN STRICT COMPLIANCE WITH
WARNING
OPERATION OF THE PRODUCT COULD CAUSE PERSONAL INJURY
OR PROPERTY DAMAGE.
INCORRECT INSTALLATION MAY CREATE A CONDITION WHERE THE