1. Manuals
  2. Consumer Electronics Support
  3. Audiovox Support
  4. Automobile Alarm Support
Support User Manuals
Question About Audiovox Automobile Alarm as-9492
wire digram shock sensor as9492 bcame unhooked nee...

wire digram shock sensor as9492 bcame unhooked need to connect wires to start truck

Asked by on 10/22/2013 1  Answer

ManualsOnline posted an answer 10 years, 6 months ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here

Rewarder User posted an answer 10 years, 1 month ago

5 Take the individual components out. Lay them on a table and then organize them. Mount the control module inside the passenger compartment up behind the dash. Don't plug the six-pin main power harness or the multi-pin input/output harness into the control module until all the connections have been made. Mount the siren in the engine compartment in a location that isn’t accessible from the bottom of the vehicle. Make sure it isn’t within the reach of hot or moving engine parts, and that the flared end of the siren is pointed down. Mount the hood and trunk pin switches in locations where water will not drain onto them, and on a grounded metal surface. Switches must be set up to allow the hood or trunk door to depress them at least ¼ inch when they close, in order for the switches to work. Install the LED light on the dash or in a highly visible area to provide a visible deterrent. The light should be easily visible from the driver's seat and from outside the car. Install the range extender antenna under the belt line of the dash for best reception. Install the valet/program/manual override switch in a location that’s accessible. You don’t need to hide this component, but you should conceal it. Mount the control switch in a location that’s accessible for you. The lower dash panel, kick panel, or glove box works well. Mount the shock sensor in a central location with a solid mounting surface that will allow the sensor to operate consistently. Install the starter inhibit relay in a location within 12 inches of the ignition switch’s low current start solenoid wire. Secure the relay to existing harness using a cable tie around the relay’s wiring harness. Arm your Audiovox car alarm using the instructions provided, and test all of the features included to make sure everything is working as designed.
Was this answer helpful?

Add Your Answer

Please Note: Do not submit personal information as it will be displayed online.
Ask a Question Request a Manual