Using the Control Panel 67
Changing the Default Settings
The default settings control many printer functions. While you
can often set these functions through your software or printer
driver, you may sometimes need to change a default setting
from the printer’s control panel using the Default Setting mode.
The following table lists the default settings and the options you
can select in Default Setting mode. The settings are explained in
detail after the table. For instructions on using Default Setting
mode, see page 72.
Settings Options
Page length for tractor Length in inches: 3, 3.5, 4, 5.5, 6, 7, 8, 8.5, 11,
70/6, 12, 14, 17
Skip over perforation On, Off
Auto tear off On, Off
Auto line feed On, Off
Print direction Bi-D, Uni-D
Software ESC/P, IBM 2380 Plus
0 slash On, Off
High speed draft On, Off
I/F mode Auto, Parallel, Serial, USB
Auto I/F wait time 10 seconds, 30 seconds
Baud rate 19200, 9600, 4800, 2400, 1200, 600, 300 BPS
Parity None, Odd, Even, Ignore
Data length 8 bit, 7 bit
Parallel I/F bidirectional
mode
On, Off
Packet mode Auto, Off
