status and error messages
Operator’s Guide 35
Error Messages
This section provides a description of
error messages that indicate possible
printer problems. Note that these errors
are warnings only, and do not cause the
print job to be lost. Once the corrective
action has been taken, printing will
resume.
Message Problem Corrective
Action
01 CLOSE THE
COVER
The printer cover is
open.
Close the cover.
02 LOAD PAPER
Printer is out of paper
.
Load paper
. Refer to page
9.
03 ADD TONER AND
CHK WASTE BOTTLE
Printer is out of toner
.
Add toner and check waste
toner bottle level. Refer to
page 24
.
04 INST
ALL T
ONER
CUP
T
oner waste bottle is
not installed or not
detected.
Install or reseat toner waste
bottle.
05 INST
ALL OPC
DRUM
The OPC drum unit is
not installed or not
detected.
Install or reseat the OPC
drum unit.
06 CLEAR JAM AT
FUSER INPUT
Entry jam sensor is on.
Clear the paper jam. Refer
to page 13
.
07 CLEAR JAM AT
FUSER EXIT
Exit jam sensor is on.
Clear the paper jam. Refer
to page 14
.
08 CLEAR JAM NEAR
TOF LEVER
Jam occurred in paper
path.
Clear the paper jam. Refer
to page 15
.
O9 CHECK TOF
LEVER
T
op of form sensor
malfunction.
Inspect top of form sensor
lever and call service if
necessary.
19 P
APER CTL ERR
Reload Paper
A paper motion error
has been detected.
Burst paper at tractors and
reload paper
. Refer to page
9.
34 REPLACE OPC
DRUM Call Service
The OPC drum unit has
exceeded its life of
30,000 printed pages.
Replace the OPC drum unit.
