5-20
SUPERSERVER 1018D-73MTF User's Manual
LAN Port Enable/Disable
Use JPL1/JPL2 to enable or disable LAN
Ports 1 and 2 on the motherboard. See
the table on the right for jumper settings.
The default setting is enabled.
LAN Port En/Disable
Jumper Settings
Setting Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
Watch Dog Enable
Watch Dog is a system monitor that can
reboot the system when a software appli-
cation hangs. Close pins 1-2 of JWD1 to
reset the system if an application hangs.
Close pins 2-3 to generate a non-mask-
able interrupt signal for the application
that hangs. See the table on the right for
jumper settings. Watch Dog must also be
enabled in the BIOS.
Watch Dog
Jumper Settings
Setting Defi nition
Pins 1-2 Reset (default)
Pins 2-3 NMI
Open Disabled
PCI-E Slot_SMB Enable
Jumper Settings
Jumper Setting Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
PCI-E Slot SMB Enable (I
2
C1/I
2
C2)
Use Jumpers I
2
C1/I
2
C2 to enable PCI-E
SMB (System Management Bus) support
to improve system management for the
PCI-E slots. See the table on the right for
jumper settings.
Backpanel USB Wake Up Enable
Close pins 1/2 of jumper JPUSB1 to
"wake up" the system when a device
installed in USB 4 or USB 5 receives an
incoming signal. See the table on the right
for jumper settings.
Backpanel USB Wake Up
Jumper Settings
Jumper Setting Defi nition
Pins 1-2 Enabled (Default)
Pins 2-3 Disabled
