4-2
M28SAB Mobile Rack User's Guide
4-3 Other Parts
When using this mobile rack independent of a chassis, you may need the follow-
ing parts.
Two 4-pin power cords to connect the mobile rack to a power supply.
•
SAS iPass cable, part numbers CBL-0108L (39 cm), CBL-0281L (75 cm) or •
CBL-0294L-01 are used to connect the SAS ports to the motherboard or RAID
controller.
4-4 Setup and Installation Steps
Use the following list as a guide to set up and install the mobile rack. If this mobile
rack is to be installed in a chassis, use the instructions in the chassis manual.
Mobile Rack Chassis Installation
Unpack and examine system parts.1.
Review all system and safety guidelines.2.
M28SAB: Install the system fan as described in section 4-7 of this manual 3.
(not required on M28SAB-OEM).
M28SAB-OEM: Reset jumper JP61 to "enable", pins 2 - 3, without the fan
connected.
Install the hard drives.4.
Connect data and power cables.5.
4-5 General Safety Guidelines
Always disconnect power cables before installing or removing any components •
from the computer, including the backplane.
Disconnect the power cable before installing or removing any cables from the
•
mobile rack or backplane.
