English - 15
# If you don’t hear a dial tone
or the display says
Registration
Failed
, charge the battery
completely, then try again.
Adapter and Battery
Information
AC Adapter for Base and Charger
Part number PS-0035
Input voltage 120V AC, 60 Hz
Output
voltage
8V AC @ 300mA
x Use only the supplied AC adapters.
x Use the proper adapter for the base & any
chargers.
x Do not place the unit in direct sunlight or
subject it to high temperatures.
Battery pack (with normal use)
Part number BT-1021
Capacity 300mAh, 2.4V DC
Talk time about 7 hours
Standby time about 7 days
Battery life about 1 year
x Replace the battery when the talk or
standby time becomes noticeably reduced.
For replacements, call the Parts Depart-
ment (see the front cover).
x When the battery gets low, the handset
beeps and shows a low battery alert;
recharge the battery.
Rechargeable Battery Warning
x is equipment contains a rechargeable
Nickel-Metal-Hydride (Ni-MH) battery.
x Nickel is a chemical known to the state of
California to cause cancer.
x Do not short-circuit the battery.
x e batteries in this equipment may
explode if disposed of in a re.
x Do not charge the batteries in any charger
other than the one specied in the owner's
manual. Using another charger may dam-
age the battery or cause it to explode.
x As part of our commitment to protecting
our environment and
conserving natural
resources, Uniden
voluntarily participates
in an RBRC® industry
program to collect and
recycle used Ni-MH
batteries within the United States. Please
call 1-800-8-BATTERY for information
on Ni-MH battery recycling in your area.
(RBRC® is a registered trademark of the
Rechargeable Battery Recycling
Corporation.)
Rechargeable batteries must be
recycled or disposed of properly.
Warning! The cords on this product
and/or accessories contain lead,
a chemical known to the state of
California to cause birth defects
or other reproductive harm. Wash
hands after handling.
Uniden works to reduce lead
content in our products &
accessories.
Compliance Information
FCC Part 68 Information
is equipment complies with Part 68 of
the FCC rules and the requirements ad-
opted by the ACTA. On the bottom of this
equipment is a label that contains, among
other information, a product identier
in the format US: AAAEQ##TXXXX. If
requested, this number must be provided
to the phone company.
An applicable Universal Service Order
Codes (USOC) certication for the jacks
used in this equipment is provided (i.e.,
RJ11C) in the packaging with each piece
of approved terminal equipment. A plug
and jack used to connect this equipment
to the premises wiring and telephone
network must comply with the applicable
FCC Part 68 rules and requirements
adopted by the ACTA. A compliant tele-
