EN - 25
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
Motor will not start.
On/Off switch is in the
“OFF” (O) position.
Turn switch to the “ON” ( | ) position.
Power cord is not
plugged in.
Plug in power cord.
Electrical outlet does
not supply adequate
power.
Try a different outlet.
Tripped pressure
washer circuit breaker
Allow to cool, and restart unit.
Power switch is ON
however gun trigger is
not squeezed ON.
With power switch ON push in on the gun
trigger which will engage the AUTO ON switch.
Unit does not reach
high pressure.
Diameter of garden
hose is too small.
Replace with a 1” (25 mm) or 5/8” (16 mm)
garden hose.
Water supply is
restricted.
Check garden hose for kinks, leaks and
blockage.
Not enough water
supply.
Open water source fully.
Pressure Tip has not
been installed on wand
assembly.
Add desired pressure tip to end of wand. See
page 19 Fig. 12 for details.
Water inlet filter is
clogged.
Remove lter and rinse in warm water.
Output pressure varies
high and low.
Not enough inlet water
supply.
Turn water on fully. Check garden hose for
kinks, leaks or blockage.
Pump is sucking air.
Check that hoses and ttings are airtight, Turn
"OFF" machine, and purge pump by squeezing
trigger gun until a steady ow of water emerge
through the spray tip.
Water inlet filter
clogged.
Remove lter and rinse in warm water.
Supply voltage below
minimum.
Verify that only the pressure washer is running
on this circuit.
Calcied gun, hose or
power spray tip.
Run distilled vinegar through detergent tank.
