12
Jack PC Hardware User Manual - Training Department
Version 0506
3.4 Existing LAN Installation
Tools you will need for Existing Jack Installation:
• Power-over-Ethernet Tester (where PoE is available (see power options 1 and 2 in
the introduction chapter) – it is recommended to verify that the LAN jack receives
power with this tester) - this is an optional accessory that you need to purchase
separately (Chip PC part number: CPN02239 – see accessories list).
• Screwdriver / Powered-screwdriver
• RJ-45 Termination Connector Block (this is an optional accessory that you need
to purchase separately)
• Half-round File to trim wall cutout
• Cloth to clean Housing contacts
• Extraction Tool to remove device after it was installed
1 Use Power-over-Ethernet tester
(Chip PC part number: CPN02239)
to check existence of PoE in the
Jack designated for installation.
Note: In case there is no PoE
available, Jack PC can be powered
by External power supply (see step
13).
2 Remove the existing LAN Jack from
the wall.
Separate the LAN Jack module from
the front panel.
3 Pull out the LAN cable, holding the
RJ-45 Termination Connector Block,
4 Connect the LAN jack and RJ-45
connector on the RJ-45 Termination
Connector Block (this is an optional
accessory that you need to purchase
separately, in case you did not order
this part – go to New installation
paragraph (3.5), and continue the
instructions in the table from step 3).
