31
16
ACCESSORIES
BLADE GUARD CONVERSION KITS:
Use the proper size blade guard for the particular
diamond blade size being operated. Consult factory for
blade guards that are available.
WEIGHT KIT: (Pro 65 III)
A rear mounted Weight Kit is available. It is standard
equipment for units shipped with 48" blade guards. It can
be purchased as an accessory for units with smaller blade
guard sizes.
WARNINGS!!!
DO turn the “ON/OFF” switch to the “0” (OFF)
position prior to connecting the machine to the
power source.
DO make sure electric powered machines are plugged
into a properly grounded circuit.
DO make sure power cords are the proper size and
in good condition.
DO follow all electrical codes in your area.
DO use correct voltage and proper extension cords.
Never carry tool by cord or yank it to disconnect
it from receptacle. Keep cord away from heat, oil
and sharp edges.
DO disconnect tools from power source when not in
use, before servicing and when changing
accessories.
DO carefully maintain and clean for better and safer
performance. Follow instructions for changing
accessories. Inspect tool cords periodically and,
if damaged, have repaired by authorized service
facility.
DO NOT lay power cords in or near the water.
DO NOT leave this machine unattended with the motor
running.
DO NOT replace the motor with any motor that does not
have a special grounding connection.
Item Part No. 35III 65III
Deluxe Light Kit 167656 181117
Tie Down Kit 167190 X X
48" Conversion Kit 191345 X
Blade Guards:
18" Slip-on 176635 X X
18" Bolt-on 174273 X X
26" Slip-on 176645 X X
26" Bolt-on 167475 X X
30" Slip-on 166911 X X
30" Bolt-on 167676 X X
36" Slip-on 166931 X
36" Bolt-on 174275 X
48" Bolt-on 166932 X
Water Pump Kit 167554 191322
Blade Stack Kit
(Std. Shaft) (4.50") 176292 X
Blade Stack Kit,
QDS Flanges:
5.00" Dia
6.00" Dia
177327
163480
X
Side Plunge Kit 191349 X
ACCESSORIES AND KITS
Notes:
1. If A Box Is NOT CHECKED, That Item Is NOT AVAILABLE For
The Saw Model Shown.
2. New Saw Models (Pro 35 III, Pro 65 III) Have Some OF These Items
Installed As Standard.
Equipment: Check Specification Sheet For Standard Features.
